Hi, I've a 2017 100D that doesn't precondition when navigating to a supercharger. No alerts or warnings of any kind show up in normal mode but upon going into service mode it showed couple alerts below.
THC_w0115_sanityBatHeater
THC_w0052_sanityPumpBat1
THC_d0005_pumpBat1
I purchased the coolant pump from the service center nearby (they said that could be the issue when I placed a service request) and replaced it today following the instructions in the manual (Battery Coolant Pump 1). Then I topped off the coolant a little bit and ran the coolant purge procedure. Next I ran the Thermal Test and it detected failure in 4/30 subcomponents. (I didn't do this procedure earlier to replacing).
BATTERY_HEATER: FAILURE
CHILLER: FAILURE
PUMPS: FAILURE
TEMPERATURE_SENSORS: FAILURE
I did notice upon powering on the car after replacing pump 1, the pump 2 went into full speed whining but pump 1 wasn't whining at all just like the old pump before I pulled it out. I pulled out the fuse F137 and it looked fine.
Any ideas why the pump1 is not running? on how to proceed next? before I replace the battery heater.
THC_w0115_sanityBatHeater
THC_w0052_sanityPumpBat1
THC_d0005_pumpBat1
I purchased the coolant pump from the service center nearby (they said that could be the issue when I placed a service request) and replaced it today following the instructions in the manual (Battery Coolant Pump 1). Then I topped off the coolant a little bit and ran the coolant purge procedure. Next I ran the Thermal Test and it detected failure in 4/30 subcomponents. (I didn't do this procedure earlier to replacing).
BATTERY_HEATER: FAILURE
CHILLER: FAILURE
PUMPS: FAILURE
TEMPERATURE_SENSORS: FAILURE
I did notice upon powering on the car after replacing pump 1, the pump 2 went into full speed whining but pump 1 wasn't whining at all just like the old pump before I pulled it out. I pulled out the fuse F137 and it looked fine.
Any ideas why the pump1 is not running? on how to proceed next? before I replace the battery heater.
Last edited: