OK, installed the Kunist.
1. Removed all fake 3M, applied true 3M automotive tape (Autozone/Amazon) cutouts, including to the two surfaces on the middle section
with missing tape. To avoid frustration, prying 3M red protective film with the back edge of a #15 scalpel really helps.
2. Alcohol wiped area after removing old splash guards.
3. Inserted the right and left tabs only by their lateral clips, ends hanging in the air.
4. Inserted middle piece into the other two hanging by the tabs.
5. Pushed right end piece middle tab in but not completely, did same on left side, then pushed them in completely once
center aligned.
6. Threaded the rubber edge pushing periodically in the right side to allow more to pull through, a 15-20 step process as
rubber sticks. Wearing rubber gloves helps a lot also.
Replaced the two stinky air filters with STP CAF15035M (one box contains two filters), using a sharp pick to pry the retaining
pins off the 4 tabs from bottom of glovebox before pulling them out, then prying right center tunnel liner starting in the corner
by the filter, tiny Torx key needed to open the screw. No more odor for a long time hopefully.
Just like in the video, this is the picture after the laser touch free car wash where I went into Service>Car Wash Mode for the first time
in two years since I got the car (dumb wetback) the two drops in the middle fell off the hood after I opened it, you can see the wet edge
where the rubber trim held the water: