I could not find a reasonably priced aftermarket adapter bracket to allow wireless iPhone charging in my 2020 LR S. I didn't think a 3-D printed part should cost $130-$160 so I looked to Thingiverse. I found a design that is modeled after the original Tesla adapter and uses an Apple MagSafe charger. That design, while very nicely done, does not work with iPhone 13/14 Pros because of the camera lens bump on those phones, and it did not fit well with the all-black Amazon charger I wanted to use - the charger was very slightly too deep and wide. I did a remix of that design and, after a couple of revisions, now have a design that should work for virtually all iPhones (at least it does for my 14 Pro and my wife's SE - pretty much the spectrum of sizes. Total cost: about $15 for printing filament, electricity and the charger. If anyone is interested, and has a 3D printer, look for "Tesla Wireless Charger Adapter for iPhone 13/14/pro" on Thingiverse. I think this will work on 2012-2020 Model S. I hope this helps someone.
Sorry, though, I don't sell 3D prints.
Sorry, though, I don't sell 3D prints.