I have both a Wall Connector and Mobile Connector in my garage (14-50 Hubbell receptacle). I used to charge at 32 amps overnight no problem, almost 1.5 years later it started disconnecting so I decide to drop amps to 24, that worked fine for a bit but it slowly got worse, more interrupts - this was on my Wall Connector. It started getting so bad I tried the Mobile Connector instead and it worked better but quickly had the same issues. They cut down to 16 amps max, interrupt all the time without much help but saying a/c issue. 2 service center stops have resulted in nothing found out but blaming my house electrical (it charged fine on their Wall Connector). The first interrupt usually happens within 20 minutes. Waiting 25min+ and opening my app forces the charging to restart, but there is zero reason to need to baby this.
The garage that these are in has a 100 amp subpanel, then runs to my house 200 amp main panel via proper gauge wiring. 6 gauge copper wiring on the Nema 14-50. Not one bit of warmth anywhere while charging. I use off peak charging since it's less expensive, so it's set to start at 11pm to start. This means my solar shouldn't interfere with anything at all - I have 2 solar arrays that up the voltage during the daytime.
Not one bit of an electrical issue going on with anything else in my house / garage. What could this be?
The garage that these are in has a 100 amp subpanel, then runs to my house 200 amp main panel via proper gauge wiring. 6 gauge copper wiring on the Nema 14-50. Not one bit of warmth anywhere while charging. I use off peak charging since it's less expensive, so it's set to start at 11pm to start. This means my solar shouldn't interfere with anything at all - I have 2 solar arrays that up the voltage during the daytime.
Not one bit of an electrical issue going on with anything else in my house / garage. What could this be?