Recent content by ilovecoffee

The holes that are already in the seal. They may look small but the vinyl tubing will fit in there as long as you cut the tubing to a sharp tip to insert it

Update: There is truth to some of the other people's anecdotal reports of vinyl tubing not resolving booming noises in their Model Y. I met with user @BrianZ last weekend, and we did 5/16" OD tubing, calibrated the hatch, with not great results. Put in 3/8" OD tubing, and the gap was too huge...

Here you go. It's a few pages back. It's the hatch and rear wheel well mostly. https://teslamotorsclub.com/tmc/posts/7876294/

Hey Guys, I got 2 Samsung A7 Lites for free and decided to do something useful with them. I wanted a safe and sturdy tablet holder for the rear seats but surprisingly no one makes an aftermarket part that uses the headrest poles for the ultimate rigidity! These things don't move over any...

Try ShiftEV in Oakville. I bet they can supply and fix. Definitely not warrantable. I also have MPP coilovers (installed by Shift) and accept the fact if the upper control arms bushings go bad like they seem to, it's just something I've got to pay for now

Outer diameter

Yeah that's weird for 5/16“ OD vinyl tubing. Given your hatch stops are in quite a bit But it does look like your rubber gasket is a bit twisted (around the tail lights) post install. I'd try to straighten it out a little. But if that doesn't resolve it then I don't think you can use tubing or...

Maybe try swapping out the tubing for something thinner? Or just make sure the tail light hatch stops aren't too over extended first off. If you unscrew them out completely temporarily does it close with an acceptable gap? If so, it's them. If not... Something isn't right with the tubing and the...

Weird can you post multiple pics of it closed and your hatch stops too. It shouldn't be that difficult or misaligned at the top against the sunroof. 5/16" OD right? Something seems weird. Edit nevermind I see your video. Those gaps aren't normal but I can't see the hatch stops. That's the...

Sorry...it is or isn't closing when you press the door closed manually?

Ok so that trim pops off and that area isn't sealed air tight? I was thinking of just popping it up a hair to allow better air flow. I haven't had a chance yet to look at the service manual but if it's not some special air seal I might give your suggestion a go.

Update: SC says the part number for the windshield has been recently updated, and there is a known issue that is supposed to be fixed by a future firmware update in regards to the camera heaters/defoggers. Not sure if I buy that but could be plausible. So for now, no impact detection or...

Hey everyone, can't seem to find many instances of this online. Had windshield replaced. As soon as cold or wet weather approaches, I get jumpy FSD visuals and on/off Front Camera Blinded errors. I always precondition my car for like 15 minutes before going somewhere. Defog is on the entire...

Those ones without the plastic nuts look too overextended to me. Start with them all turned in as far as possible, then adjust the tail light ones outwards at the same time with the same amount until it grips paper. Then follow up with the other ones extending them until they grip a paper...

Let's talk Lock Chimes. I spent about 30 minutes curating some sounds that I felt were sophisticated, short, and hopefully loud enough to hear on the PWS. I didn't want anything funny or corny. I've converted them all to wav and made sure they are under 1mb...