Probably what you did, but to be sure, after firmware update: To check or change the configuration of the wall connector: you must either reset the breaker or press the button on the wall connector handle for 5 to 10 seconds for the wall connector to enable its own time limited WiFi network. Then you must connect your WiFi to this time-limited WiFi network ID using your phone or computer within 5 minutes. Its SSID will look something like: "TeslaWallConnector_9595994". Then you must connect to the wall connector on its network by entering 192.168.92.1 in your web browser. This is the only way you can configure the wall connector or really check it out.
Remember to reconnect you phone or computer back to your normal WiFi network when you are finished configuring the Wall Connector.
Remember to reconnect you phone or computer back to your normal WiFi network when you are finished configuring the Wall Connector.
Last edited: