Are you sure the red gray wire is putting out power?I got all the panels pulled off with relatively little difficulty. I was able to swap out the bars on both sides with the cables running towards the controller home. I was able to tap into the red/grey wire as part of the white connector shown in pictures earlier in the thread (with the ground on a nearby nut) and the wire has been run through the headliner over to the controller. Everything is connected into the controller securely.
However, when I double click the fob to unlock the trunk, the latch on the liftgate just clicks and no movement happens. Since the latch clicks, that means it's getting power, right? Could it be possible that I have a defective product? I'm really stumped as to what to do since the instructions are lacking and it seems like the manufacturer has communication issues. From the posts on this thread and the other one, it seems like I have everything set up correctly, so what would this mean? I'm wondering if the red/grey wire is the wrong one.
Help!
This may be related but does anyone know what purpose the little yellow wires serve? I have them connected near the controller (from where the purple power connects into the controller and where the button and latch connection comes from) but I'm not sure whether the other end (that connects to the power source) needs to be tapped into something; the other posts don't seem to say anything about it so is it safe to assume it's not needed?
If you watch my walkthrough video, I did not have a grey red wire. I had to use the solid gray wire for power