Something to take your mind off EDD's for a moment.
Since my wall charger location was so close to the breaker panel, I decided I could do it myself and save some $$$. Total parts cost = 135.68. It took me almost three weeks of watching/re-watching youtube videos, figuring out/buying which parts were needed, returning those parts I found out I didn't need and buying other parts I realized I now needed. NOTE: 6 gauge wire is hard to bend and cut! Especially when you have light duty pliers/wirecutters. In the end, I bought the right tools, a day late and dollar short. Also, miscalculated wire length and found out my white wire (used for ground in this case) was too short and had to crimp a vinyl butt connector to extend it to the ground bar. Cinder block wall is a bit more challenging. Couldn't get a sharp 90 deg conduit bend to the adjoining wall, so there's an inch or two of exposed wiring. Not a totally pro install, but hey, it works! Too much fun! Now all I need is something to charge...
Note: Installed 60 amp breaker using 6/3 romex stranded wire so I can get the full 48 amp charge.