Welcome to Tesla Motors Club
Discuss Tesla's Model S, Model 3, Model X, Model Y, Cybertruck, Roadster and More.
Register

Rally Armor Mud Flaps on Refresh Model S

This site may earn commission on affiliate links.
Here is an alternative oem style mud flaps for refreshed Model S
 
  • Like
Reactions: gbailey
Here is an alternative oem style mud flaps for refreshed Model S
Actually these ones seem good. I'll check them out.

Can you trim down the front flaps? They seem long / will run against everything.
 
Actually these ones seem good. I'll check them out.

Can you trim down the front flaps? They seem long / will run against everything.
Yes, we know this issue that will scratch when it runs over a bump or slope.
They are customed-design for the size is best fit the refreshed Model S.
1699252442384.jpeg
 
  • Like
Reactions: gbailey

Attachments

  • 16993280104146197032590546594761.jpg
    16993280104146197032590546594761.jpg
    392.8 KB · Views: 84
  • 16993280562764549569325659234539.jpg
    16993280562764549569325659234539.jpg
    381.2 KB · Views: 83
  • 16993280902216836833848474302774.jpg
    16993280902216836833848474302774.jpg
    406.8 KB · Views: 90
All good, love them!

They even have a small patch to put behind the plastic and the car for where you put the metal clip to avoid chip.
 

Attachments

  • IMG_6397.jpeg
    IMG_6397.jpeg
    344.7 KB · Views: 72
  • IMG_6396.jpeg
    IMG_6396.jpeg
    475.9 KB · Views: 79
  • IMG_6395.jpeg
    IMG_6395.jpeg
    445.3 KB · Views: 83
  • IMG_6394.jpeg
    IMG_6394.jpeg
    283.2 KB · Views: 77
  • IMG_6393.jpeg
    IMG_6393.jpeg
    355.7 KB · Views: 67
  • IMG_6392.jpeg
    IMG_6392.jpeg
    290.2 KB · Views: 66
  • IMG_6391.jpeg
    IMG_6391.jpeg
    415.9 KB · Views: 57
  • IMG_6390.jpeg
    IMG_6390.jpeg
    342.5 KB · Views: 59
Here is an alternative oem style mud flaps for refreshed Model S
I have similar ones, not quite as long and they dug into the paint on the rear flaps. Will these cause the same issue?
 
Here is an alternative oem style mud flaps for refreshed Model S
I returned these as the bottom portion for the front are too short. Pulled on my plastic rocker tab and broke them off. No way to fix unless you replace the ENTIRE rocker panel 🤬the oem tesla ones are way better, albeit low and scrap everywhere.
Anyone know what kind of tape I should use to hold the plastic piece to the rocker panel? duct tape fails over time. Currently have packing tape holding it there. Lol
 

Attachments

  • IMG_0550.jpeg
    IMG_0550.jpeg
    405.8 KB · Views: 44
  • IMG_0551.jpeg
    IMG_0551.jpeg
    380.5 KB · Views: 43
  • IMG_0552.jpeg
    IMG_0552.jpeg
    361.1 KB · Views: 42