HankLloydRight
No Roads
red "Clear Auto Connect" bars.
That only appears after you've successfully connected to a controller, so you can turn it off in case you want to connect to a different controller.
You can install our site as a web app on your iOS device by utilizing the Add to Home Screen feature in Safari. Please see this thread for more details on this.
Note: This feature may not be available in some browsers.
red "Clear Auto Connect" bars.
Hank:
Just downloaded the app to my iPhone 6. When I launch it, it searches but does not find the controller. Yes, car is powered up and appliqué is illuminated. Any hints?
Thx.
You might want to try turning off LTE on the phone when trying to pair a bluetooth device for the first time. I've had issues in the past that were quickly resolved when I've done that.
I'm sure you can figure out how to turn off LTE, but one simple way on my phone was to just enable airplane mode, and then turn bluetooth back on separately.
Once paired, you'll probably never have to jump through those hoops again. I'd try that.
While your advice is sound and worth a try, the Appliqué module is a BLE device (Bluetooth Low Energy) and doesn't pair like normal BT devices. It's more of an instantaneous connection.
The devices I had issues with where turning off LTE made the difference were FOBO Tire Plus, and another similar FOBO product. I don't know if those are BLE devices or not.
Yes, FOBO is BLE. What I was trying to get across was that users of the Applique module and app do not have to go into Bluetooth settings and attempt to "pair" the device, since it won't show up there.
Are you in or near the car? It won't find it if you'r more than about 50 feet away? When it connects you'll see a black bar with the controller ID under the green "Scan for Controllers" and red "Clear Auto Connect" bars.
Ahh, well, then I think it is even more likely that turning off LTE will allow JPP to pair.
LTE off did not help. I made sure power was on--even had the appliqué working to be sure. Tried holding my iPhone next to the controller. I wonder since I have one of the early controllers, is there some manual configuration or trick I need to do?
FWIW, I launched the Bluefruit LE app. It sees my 4 FOBO tire sensors and the FOBO unit inside the car, plus my 3 Tile tags. Does not see the applique controller. Maybe next I will power cycle the controller....