2019 Model 3, 2wd, std range. Wife crashed through a deep puddle today, it blew the front belly pan off and soaked the area under the frunk (even blew front hubcaps off). She had some water dripping on her feet, so I removed driver under dash panels (airbag to my surprise) and the frunk looking for a seam that might have allowed the leak. While inspecting under the frunk I found a loose connector at the lower passenger side of the windshield. It looks to have three wires that hook directly to the windshield and there was a mating connector in the same area for the windshield to plug into. Before I reconnect it, I'd like to know what the three wires are for that connect to the windshield. I should note, not long ago, I had to pay tesla to replace a harness under the frunk area and I assume they left this connector unplugged. Question is, did they forget, or is it not required. I did find a tiny gap in a pinch weld where the water probably entered which I'll try to seal. Here is a pic of the connector I found not plugged in. I could not locate where the harness clip is supposed to plug into either, but I'll keep looking. Thanks in advance.