Search results

https://dmv2u.oregon.gov/eServices/_/#1 If the link makes you "start over", its the 3rd option down from the "registration" tab which is located in the center of the page towards the top..

Can you send me a private message? I can't seem to find out how..

Could you send me a private message? Can’t seem to figure out how.

You just need 1/2" on the sides. I use a 1" roll and cut it in half after cutting the entire length I need and use each half for each side. Hope that makes sense.

We do a lot of XPEL wraps at my shop and so we need to remove the factory spoiler quiet often and install it back on after the wrap. I have not seen one factory installed one that sits nice and flush against the trunk. The ends are always lifted. We remove the factory double sided tape and...

Yes, the aligned it as well. They also installed new tires and wheels for me. I understand the drive, but since they are experienced on these cars and specialize in race car suspension on a daily basis, I wouldn't trust anyone else with it.

I recommend AR Motorsports in Tigard, OR. They lowered my 3 on Motion Control Suspension

Yes, it is very similar to nardo gray. We wrapped it and also applied XPEL PPF on the full front and rockers to preserve the wrap against rock chips damage!

Thank you!

Lowered on Motion Control Suspension (MCS)

If you really want to see if its aligned straight on the hood or not, open the frunk and eye the line of the emblem to the latch!

I have the same issue, been meaning to ask service about it.

Can you send me a message with your contact number? I can't seem to figure out how to send a message. Thanks

Don’t be surprised if they work themself out. When I picked mine up I had a crease on the back seat that looked similar to your driver seat and it went back to its original state after a couple days.

I'm not capable of sending a PM, maybe because my account is new? Can you please contact me. I would like a set of 4 of the version 2. Let me know if you can not send me a PM..

I found the 3D mats from 1010 tires for $189 shipped. Should be receiving mine today. Placed the order 4 days ago.. Here is the link. Kagu-Floormat 3D MAXpider Kagu Car Floor Mat

I am not comparing apples to apples. It does not require a electrician to take on this job. For example I'm not going to install a roof on my house.. There are some things we all can and are capable of doing without hiring a professional. I didn't ask how to wire up the connector to the panel or...

Thank you all for the help. To be honest maybe I sounded like I didn’t do any research etc before starting this thread but I have. I’m just that guy that reads 50 times before doing something. I basically had to directly ask and get the answer for myself . Anyway, again I know working with...

There is definitely a difference. We just wrapped a solid black Model 3 last week at my shop and we will be wrapping a model x in obsidian black next week. The metallic flakes definitely still show through the stealth PPF under the sun. I personally like it better on solid black..

So anyone who asks a question should keep it to themself and call a professional? Lol. I understand working with electrical is not a joke and the risks that come with it. I’ve done other type of electrical work and just want to confirm the type of wire on this specific project.

Hello everyone, I am going to be installing the wall connector myself but want to confirm what wires to go with in what type of conduit. I am going to run around 35' feet as I will be installing the wall connector on the opposite side of my garage that the breaker box is on (two car garage door...