Search results

This Gen 2 wall connector has now been sold. Thank you!

Gen 2 Wall Connector, 80A, white, 24’ cable, used I have updated to Gen 3 units for load sharing. This unit has worked flawlessly for 3 years, and while it supports load sharing with other Gen 2 units, it cannot share with a Gen 3. It was decommissioned by an electrician, has the mounting plate...

On the question of four or fewer, apologies for overstating that as a requirement, it isn't. It is however a recommendation, and a suitable upper limit for our circumstances. And we have only two wall connectors, so we are under the recommended limit. Here's how we calculated it: Power sharing...

Hi @Sophias_dad, you may be misinterpreting the two pictorial examples on page 24, which are not normative requirements. There is no statement requiring breakers per unit. The normative specification on page 24 is "Power sharing circuits may be installed in an electrical panel that supports...

Sigh. This was installed by a Tesla-qualified electrician. This is all they do... EV charger installs. End-users cannot install load sharing Gen 3 units as DIY — special instructions and firmware add-on is required that Tesla makes available only to qualified installers. The J-box and buss bars...

Oops... The units were installed on Jan 3, 2022, last week, not 2021! Sheesh. This happens every year.

My wife just bought a VW ID.4 and we want to charge it on the same circuit I previously installed to charge my Model 3. Here are a few notes on what we did and how it's working: I upgraded the Gen 2 HPWC to a Gen 3 and bought a second Gen 3. These were installed on Jan 3, 2021. We are using the...

I believe this is not quite right. I have a Gen 2 and looking to add this one, if it shows up again. The J1772 Gen 2 would be added to my system as a "Slave" unit, with the amperage indicator set to "F" (F - Slave mode - N/A, see page 22 in the Wall Connector user manual, the amperage cannot be...