Search results

It's the actual door handle itself. Old one metal and new black is plastic. Screwed in from the back. Need to remove door panel and the whole door handle assembly and then replace handle. With a professionally done $500 chrome delete you get the exact same result:)

Have you done any spirited driving in a Taycan AWD?

Sold mine for $9k w/ 150k miles

1004794-00-B is around $60 from Tesla Disconnected the old antenna, taped it up and tucked it back in. Since I have the Plaid liftgate trim I had one of the original clip holes unused so I drilled that larger and pulled the connector through there. Then put on some NVH foam on the antenna and...

It works without, but it's nice to have. It comes with the Tesla Store bought kit. Installed and works great with Pixel 8 Pro

Soooo, has anyone with a Performance Plus car compared it to a Plaid? Super curious if the Plaid is as stiff.

Unfortunately #35 is very much needed. The stock plastic piece does not have a cutout for the cable coming out of the charging pad... See video:

I do not recommend using non-original batteries as the car has a gateway code for what type of battery is used. This code is probably attached to how the DC-DC will keep the 12v charged.

Goes to various places. You are missing the car side harness. You should contact the Ebay seller

Prior Design

Done many times. Even have a how-to on my website. If you go far enough back you can have the fw pre-nerf. It's just up to you if you want to have a safe car or one that is at risk of fire :)

Going to be an addition to mine as soon as I figure out what the situation is with my car.

Downgrade fw and so it yourself with gwxfer

You can ignore that wire. Not used for the install on EU vehicles.

Experiencing this as well after lots of water on road. Narrowed it down to an isolation fault between the hvjb and the hv rapid mate connector. I am really hoping a replacement of this solves the issue and that a complete pack isn't necessary. Experienced the exact same thing one year ago...

Current look. Full facelift exterior, but I'm currently planning a complete visual overhaul.

It is absolutely possible, but I would recommend just swapping cars. If you do, make sure it has the optional Ludi upgrade. Some 90s don't. Also, make sure you buy a v3

Yes

The entire light bar will be brighter for rear fog

Thread 'Air Suspension compressor turns on, then off after 7 seconds...' Air Suspension compressor turns on, then off after 7 seconds...

If anyone here is located in Cali, reach out to EVFIXME instead and have this done the OEM way without expensive emulators that will most likely eventually fail due to shitty design :) Also, where does Xenon vs LED come into the equation. To me the Xenon lights looks outdated AF.

Sounds like a cool project. The dump-box doesn't have any buttons or switches. It is all done through the remote

You have to unlock the diag port on .16 first with either factory mode or service mode+. Has to be done with TBX3

What brake rotors do you have?

That looks like absolute poverty

Compressor has to run for quite a bit each time. It's pretty quick to lift it if you have lowering links so you don't really have to wait too long until you can drive. It will run for a while to refill the res and be happy with the level.

No issues so far. Fairly easy to install

Got DropX dropbox instead. Works fantastic with remote

Thanks. I have ordered #41. Eager to get wireless charging installed and ditch the cable :)

It's not a ton of work if you're a little handy, but if you can get it to work via subscription then I would probably just eat that cost

2022.8.10.5

Update?

Just gotta live with it or find a tyre size that makes it identical to 19" or 21". I chose 21" in the menu because it gives better range estimates compared to 19" option.

I'm still waiting on the new revision which now is estimated Q1 2024. Mine is disconnected for the moment due to dead LEDs.

It's pretty damn close. The LED is smoother than the dotted look on the original 2012-2021 taillights, but the color is great. If you do a medium tint on your taillights it looks absolutely killer. No tint: Tinted Skyfol medium:

Option 3: Downgrade fw to 2022.8.10.5 and change config yourself with gwxfer script

My guide has been updated with AP1 radar relocation. This does require a way to change gw config and Toolbox for calibration. Just did this facelift again on my new AP1 car and it was smooth sailing. I also extended the wiring for park sensors.

B revision so probably, hopefully - never had an issue across 2 S'

Original, over the counter from Tesla

Takeoff!

Yes. This still work and I mention exactly this in my guide. I should probably make a guide on how to get into factory mode without Buddy.

Low & slow

I have now had to the chance to test my pre-april Plus suspension over a lot of kilometers this summer. I have tested both with lowering links (+9mm all around) and both premium UHP tires (Pilot SuperSport) and budget tires and wow... what a fantastic machine. Do not skimp out on tires for this...

Most likely the first pre-Palladium car in the world with the new liftgate trim. Will probably do a write-up on my website eventually because it requires some modifications :) /antiplasticsquad

It's legit but the quality is not good. Wait for new version. Can also be found on Aliexpress

Just facelifted my S and added custom headlights from EVEGO ❤️

Take a hammer and hammer it out from the opposite end of the torx head. You probably have to use a short metal rod or drill bit to hammer on. Having a jack or jackstand on the knuckle assembly to relieve stress is also recommended. I hope you understand what I mean. The bolt is not screwed into...