Very easy Wayne...grab the soft top roof pillar (between the windshield & the roll bar), and gently twist it towards you...this takes the tension off of the locking pins...with the tension neutralized, slide one of the locking pins in, towards the middle of the car, and gently raise the front of the roff pillar out of it's seated, locked position...now, with one side out, there will be no tension... gently pull the locking pin for the other end of the roof pillar in, and fold the roof back towards the middle of the car, draping it over one of the (two) roof supports....go to the other side of the car, and repeat the process...remove the roof, fold it gently, and put it in the trunk...then grab one end of one of the two roof supports, and apply gentle but consistent pressure pulling the end straight out of the support seated position (either in the rollbar, or the top of the windshield)...once you have removed one end of the support, you an easily remove the other (as there is no longer any tension)...remove both roll supports and place them in the trunk, and you're done!
Important, don't place any of the roof components on the PEM...if you do, and forget about them and try to close the trunk, you will damage the CF trunk!
Looks like a great day for a Roadster drive...enjoy!!!