With the assistance of @strider my factory low beams were recently upgraded to 55W 5000K Xenons using the DDM Kit and now I want to aim the headlights slightly higher. I found the post shown below in an old thread about headlight fogging.
Can anyone offer advice about which direction to turn the white adjustment knob to raise the headlight aim point, and does turning that knob simultaneously change the beam angle in the horizontal plane as well (@cinergi says it does), and in which direction?
I'm disappointed that the Roadster Owners Manual does not contain any info on adjusting the headlights.
Thanks!
Can anyone offer advice about which direction to turn the white adjustment knob to raise the headlight aim point, and does turning that knob simultaneously change the beam angle in the horizontal plane as well (@cinergi says it does), and in which direction?
I'm disappointed that the Roadster Owners Manual does not contain any info on adjusting the headlights.
Thanks!
Turn the wheel out:
So you can access this (and 3 other 10mm) screws:
So you can access the white 10mm plastic adjustment screw in front of the white cap (IOW, the closer of the two white objects) here:
Turn to adjust the height (and at the same time, left/right throw). Not sure how to adjust only the height. This was the screw the tech was adjusting -- it's possible there's another one that's height-only as I was getting changes I didn't really want by turning this screw.