I attached pictures and also a video. Its hard to capture on camera, but it is getting quite bad. Just noticed it today. The crease spot is directly along the line where the underside support is glued to the hood. It is following the sharp EDGE of that support perfectly. Opinions how I should proceed? I don't want to be "that annoying customer" that complains about every stinking little thing... Especially after they just tossed a brand new battery in my car...And so clarify before anyone asks, that crease is popping UP, from the inside out, not from the outside in. No, didn't overload the Frunk or Slam it either. And when I open the hood and flex the hood (wiggle it up and down) you can see that spot flex as well.....
Ideas, opinions, etc...???
It is A LOT more visible then the camera captures.
Ideas, opinions, etc...???
It is A LOT more visible then the camera captures.
Last edited by a moderator: